Close this window to return to series
500 project listing
“Gone
Fishin” by Die Cuts with a View
Materials
Needed
Die Cut Overlays™ - Matchmaker
Photo
Overlay
Metal tag
Cardstock
Twine
Thin wire
Photos
Instructions
1.
Take an 8”x8” matchmaker overlay and
adhere one side of the overlay to the edge of a piece of 8”x8”
cardstock allowing the other three sides of the overlay to open
freely.
2.
Trim down four photos to approximately 3-1/2”
square and mount photos in overlay openings, using the overlay as
a guide of where to place the photos.
3.
While the overlay is still loose, wrap a piece of
twine around top center divider and tie a hook made out of wire
onto the bottom of the twine.
4.
Thread another piece of twine through a metal tag
and tie to another divider. Write “Gone Fishin” on tag
and adhere to page. After everything is completed, adhere down the
rest of the overlay to secure photos.
Product Tips for:
Overlays • Double mounted
overlays are separate so you can match different colors to make
a different appearance. • Entire line
of “Matchmaker” products is available including, cardstock,
patterned paper, matstacks, and cardstock strips. All in coordinating
colors and designs.
